![]() It is not necessary to remove the failed screw the hole can be fixed by mudding it over with taping compound during the finishing process. If you hear a popping sound, it means the head of the screw has punctured the paper, and that you'll need to drive another screw alongside the failed one. This means that the screw is not properly holding the drywall to the stud. Should you drive the screw too far, the screw head will completely puncture the paper and end up buried in the gypsum core of the drywall panel. But if you don't drive far enough, it will be difficult, if not impossible, to cover the screw head with taping compound. If the edges are sharp, that means that the screw went down too far. When the screw is perfectly sunk, the edges of the paper around the circle will be slightly rounded inward. Get the best deals on Grabber Phillips Industrial Screws & Bolts when you shop the. Slow and stop the drill as the head of the screw reaches the paper and a dimple forms. Just make sure the driver bit is secure on the head, give the drill some pressure, and slowly begin screwing again. ![]() The best option, if you can do it, is to drive and sink the screw head in one smooth action, without stopping the drill. Slow, consistent speed results in a better-installed drywall screw.
0 Comments
Leave a Reply. |